The remodeling is not quite done yet. There were a couple of things that still bugged me, the worst being the kitchen counter. There is an almost-square section between the refrigerator and the stove, not very big but used very much because of its location. It is also a corner piece, and because I selected a rolled edge for the counter top, there was a big fat seam running up the middle of it, from inside corner to out. I had been told the counter top would have seams, and I thought that was just a cosmetic problem, not a functional one. Now I know better, especially after this particular seam developed a hump.
Eventually, the manufacturing rep showed up and deemed it fixable, but the fix is not 100% perfect. When a glass or plate slides across the seam, it bumps. If I had hired Joe Blow to install the counter top, I would have let it go. But for the amount of money I am paying, I want things to be as close to perfection as possible. I'll ruin them later myself.
I wasn't getting anywhere with the project managers I had been working with, so I went right to the top, asking the owner/president to come take a look. We go a ways back, as this company has done much work for me over the years. And he agreed that the seam just was not right.
So that part of the counter top is to be replaced with one that has no seam. This means no rolled edge on that section, but I would be surprised if anyone notices that. Once that is fixed, I can stop fretting and start enjoying my "new" house. (Fingers crossed.)